Mark MPM Serie Instrucciones De Uso página 4

ENGLISH
A. INPUT CHANNEL SECTION
1. BALANCE INPUT
Electronially Balanced inputs acceptable a standard XLR male connector.
+ 48V Phantom Power available on each input Mic socket.
and this switch is on Rear Phantom Power.
2. LINE INPUT
The unbalanced Mic input is provided for the use of a unbalance mic and is
designed to accept a unbalanced high impedance input signal.
(This use for connection Deck, Turntable, Keyboard etc..)
3. PEAK (PEAK LEVEL INDICATOR)
A red LED indicates a signal level at the insert return point, premaster fader ,
It illuminates at approximately 5dB below clipping.
4. GAIN CONTROL
Adjusts input sensitivity from -60dB to -20dB with the -20dB pad switch in
the out position, and -40dB to 0dB when the -20dB pad switch is pushed.
5. PAD (-20dB)
When push this switch, attenuates the input signal -20dB.
6. HIGH
Control the high frequency tone of each channel. Always set this control to
the 12 o'clock position, but you can control the high frequency tone
according to the speaker, the conditions of listening position and listener's
taste. Clockwise rotation of the control increases level.
7. MID
Control the mid frequency tone of each channel. Always set this control to
the 12 o'clock position, but you can control the mid frequency tone
according to the speaker, the conditions of listening position and listener's
taste. Clockwise rotation of the control increases level.
8. LOW
Control the low frequency tone of each channel. Always set this control to
the 12 o'clck position, but you can control the low frequency tone according
to the speaker, the conditions of listening position and listener's state.
Clockwise rotation of the control increase the level.
9. AUX
This is normally derived after the EQ section and channel fader (PRE-
FADER, POSE-EQ), and is therefore unaffected by the fader position and
routing status. This makes the send particularly suitable for foldback or
monitor feeds, which need to be controlled separately from the main P.A.
mix. All pre-fader sends may be selected intrnally to be PRE-FADER, PRE-
EQ.
10. REV
Use this control when you want to get effect sound by adjustment of input
signal. When you don't use external souce, digital delay will be working
which installed inside.
MPM 8302 USB / MPM 16352 USB 2 User manual/Manual de Uso
1
MIC
1
2
LINE
3
PEAK
GAIN
4
PAD
5
-20dB
HI
12KHz
6
MID
2.5KHZ
7
LOW
80HZ
8
AUX
9
REV
10