Assembling Instructions - Nemaxx SD20X Instrucciones De Uso

KEN001SD
SD20X SOLAR SHOWER INSTRUCTIONS
Fig. 1

ASSEMBLING INSTRUCTIONS

1. Choose a location for shower which will receive as much
sunlight as possible.
2. Mount the shower base to concrete slab or wood base with
four bolts, nuts and gaskets. We recommend to use a
wrench. Fig. 1
3. Connect shower head to black shower tube. We recommend
NOT to use a wrench.
NOTE: Don't forget gasket when connecting the shower
head.
4. If shower is comes with foot shower, connect foot shower to
shower body with the adjust nut. Fig. 2
5. Attach hose connector to inlet of shower. Fig. 1
6. Attach garden hose to hose connector and water supply.
INITIAL SET UP OF THE SHOWER
1. Turn the shower handle to FULL ON HOT position.
NOTE: Filling tube with valve in hot position ensures that no
air pockets are trapped in shower. This procedure is used for
initial set up only.
2. Turn on water supply to garden hose to fill the shower. It will
take 2 to 3 minutes to fill up the shower.
3. When water flows from shower head, turn the shower handle
off. Turning shower handle off makes water begin heating in
tube.
4. Depending on available sunlight and outside temperature,
the shower will take one to two hours to fully heat water.
5. Water temperature in shower can reach 60ºC in strong
sunshine.
EN
Adjust nut
Fig. 2
2
Version: 4.0
04.05.2017
Gasket
Shower head
Upper tube
Adjust nut
Gasket
Handle
Lower Tube
Foot washer
Gasket
Hose connector
Bolts
Washers
Nuts
Gasket