Nolan N53 Seguridad E Instrucciones página 11

- Do not install the peak without the internal trims of the latches.
- In case of malfunctioning or damages, please contact an authorized Nolan dealer.
REMOVABLE INNER COMFORT PADDING
4. Cheek Pad Disassembly
4.1. Unfasten the chin strap (see instructions).
4.2. Pull the back of the left cheek pad towards the inside of the helmet to undo the
snap fastener on its back (Fig. 4).
4.3. Remove the front flap of the left cheek pad from the corresponding seat in the
inner chin guard (Fig. 5).
4.4. Remove the chin strap from the elastic loop on the strap (Fig. 6).
4.5. Completely remove the left cheek pad from the helmet by pulling the chin strap
out of the slot on the left cheek pad.
4.6. Repeat these steps with the right cheek pad.
Note: Do not remove the polystyrene cheek pads from the helmet shell.
5. Liner disassembly
5.1. Pull the back of the comfort padding towards the inside of the helmet to unho-
ok the two side buttons on its back from their seats on the rear support fixed to
the polystyrene inner shell (Fig. 7).
5.2. Unhook the left front flap from the support fixed to the inner shell by slightly pul-
ling the comfort padding towards the inside of the helmet (Fig. 8). Repeat the
same steps for the right front and central front flaps.
5.3. Completely remove the comfort padding from the helmet.
6. Liner Assembly
6.1. Properly insert the comfort padding into the helmet.
6.2. Hook the front left flap to its seat on the support fixed to the inner shell by sli-
ghtly pushing the liner towards the outside of the helmet (Fig. 8). Repeat the
same steps for the right front and central front flaps.
6.3. Hook the two side buttons on the back of the comfort padding to the corre-
sponding seats on the rear support fixed to the polystyrene inner shell (Fig. 7).
6.4. Stretch the inner comfort padding so that it adheres to the inner shell.
7. Cheek Pad Assembly
7.1. Pull the rectangular textile extension on the back of the left cheek pad and
insert the chin strap into the corresponding slot, extending it out from the oppo-
site side of the padding (Fig. 9).
7.2. Insert the left chin strap in the elastic loop on the strap embedded in the left
cheek pad (Fig. 6). Pull the strap towards the inside of the helmet.
7.3. Insert the front flap of the left cheek pad into the corresponding seat in the inner
chin guard (Fig. 5).
7.4. Hook the button on the back of the left cheek pad to the corresponding seat on
the polystyrene cheek pad (Fig. 4). Then press the upper part of the cheek pad
so that it adheres to the inner polystyrene cheek pad.
11