Selecting The Installation Location; Installation Diagram; Outdoor Unit - Mitsubishi Electric Mr.SLIM SUZ-KA09 Para El Instalador

2. Selecting the installation location

2.1. Outdoor unit

or vibration.
legs.
Note:
direct sunlight or excessive water can be avoided as much as possible.
SUZ-KA09, KA12, KA15NA
right, or rear side.
Unit: inch
31-1/2
5-
19-11/16
15/16
Air inlet
Air outlet
2-3/8 × 13/16 slot
1-9/16
and the piping or wrap 7 to 8 turns of insulation vinyl tape around the piping.
Units should be installed by licensed contractor accordingly to local code requirement.
Note:
Drain piping for outdoor unit
The outdoor unit produces condensate during the heating operation. Select the installation place to ensure to prevent the outdoor unit and/or the grounds from being wet
-
Basically open 4 in.
(100 mm) or more without
any obstruction in front and
on both sides of the unit.
4 in.
(100 mm)
or more
Unit: mm
800
500
150
Air inlet
Air outlet
2-10 × 21 slot
40
Caution:
instructions described below.
posed directly to wind.
Avoid the following places for installation where air conditioner trouble is liable to
occur.
The outdoor unit produces condensate during the heating operation. Select the in-
stallation place to ensure to prevent the outdoor unit and/or the grounds from being
SUZ-KA18NA
Unit: inch
33-1/16
19-11/16
6-5/8
Air inlet
Air outlet
4-3/8 × 13/16 slot
1-9/16
20 in. (500 mm)
or more
Unit: mm
840
500
169
Air inlet
Air outlet
slot
4-10 × 21
40
-
3