Setting The Alarm Time - iCES ICR-240 Manual De Instrucciones

• The time can only be set when the radio is turned off. Press the "ON / OFF /
NAP" button (2) to turn the radio on or off.
• When the clock display is blinking, you cannot power on the radio by the "ON
/ OFF / NAP" button (2).
1. Press and hold down the "TIME / PRESET" button (6) for approximately 3
seconds until the display flashes.
2. Press the "HOUR / TUNING –" button (5) repeatedly to change the hour
setting.
3. Press the "MIN / TUNING +" button (9) repeatedly to change the minute
setting.
4. Press the "TIME / PRESET" button (6) to confirm at the time and the display
will stop flashing.

SETTING THE ALARM TIME

This clock radio has dual alarms that can be set and used independently. The
procedure to set both alarms are the same. Both alarms can either sound the
buzzer or wake up to radio.
Note: The alarm time can only be set when the radio is turned off. Press the "ON
/ OFF / NAP" button (2) to turn radio on or off.
1. For setting alarm time 1 with buzzer, press "ALARM 1 / VOL –" button (4)
and indicator (E) will flash. For setting alarm time 1 with radio, press
"ALARM 1 / VOL –" button (4) twice and the
2. When the digits are flashing, press the "HOUR / TUNING –" button (5)
repeatedly to change the hour setting. Press the "MIN / TUNING +" button (9)
repeatedly to change the minute setting.
3. Press the "ALARM 1 / VOL –" button (4) to confirm.
4. To cancel alarm, press the "ALARM 1 / VOL –" button (4) three times when the
current time is showing. The alarm indicators will be off.
5. When the alarm sounds, press any button to turn off alarm or press the
"SNOOZE / SLEEP / DIM" button (1) to enter snooze mode.
blink during snooze mode. The alarm will sound again after 5 minutes. The
alarm buzzer does not cut the radio sound. If the alarm waking up by radio is
activated, the volume control for the radio is not available.
6. Follow the same instructions for alarm 2 with the "ALARM 2 / VOL +" button
(8).
indicator (F) will flash.
5
or will