Service Information - BLACK&DECKER LD112 Manual De Instrucciones

Atornillador/taladro con batería de ión-litio de 12v max
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

24 • ENGLISH
f Hold the drill firmly with two hands to control its
twisting action.
f Do not click the trigger of a stalled drill off and
on in an attempt to start it. Damage to the drill
can result.
f Minimize stalling on breakthrough by reducing
pressure and slowly drilling through the last part
of the hole.
f Keep the motor running while pulling the bit out of
a drilled hole. This will help reduce jamming.
f Make sure switch turns drill on and off.
Drilling in wood
Holes in wood can be made with the same twist drill bits
used for metal or with spade bits. These bits should be
sharp and should be pulled out frequently when drilling to
clear chips from the flutes.
Drilling in metal
Use a cutting lubricant when drilling metals. The exceptions
are cast iron and brass which should be drilled dry. The
cutting lubricants that work best are sulfurized cutting oil
or lard oil.
Drilling in masonry
Use carbide tipped masonry bits. Refer to Drilling section.
Keep even force on the drill but not so much that you crack
the brittle material. A smooth, even flow of dust indicates
the proper drilling rate.
MAINTENANCE
Use only mild soap and damp cloth to clean the tool. Never
let any liquid get inside the tool; never immerse any part of
the tool into a liquid.
Important! To assure product SAFETY and RELIABILITY,
repairs, maintenance and adjustment (other than those
listed in this manual) should be performed by authorized
service centers or other qualified service personnel,
always using identical replacement parts.
PROTECTING THE ENVIRONMENT
Separate collection. This product must not be
disposed of with normal household waste.
Should you find one day that your Black & Decker
product needs replacement, or if it is of no further
use to you, do not dispose of it with household
waste. Make this product available for separate
collection.
Separate collection of used products and packaging
allows materials to be recycled and used again.
Re-use of recycled materials helps prevent
environmental pollution and reduces the demand
for raw materials. Local regulations may provide for
separate collection of electrical products from the household,
at municipal waste sites or by the retailer when you purchase
a new product.

SERVICE INFORMATION

Black & Decker offers a full network of company-owned and
authorized service locations. All Black & Decker Service
Centers are staffed with trained personnel to provide
customers with efficient and reliable power tool service.
For more information about our authorized service centers
and if you need technical advice, repair, or genuine factory
replacement parts, contact the Black & Decker location
nearest you, or visit us at www.BlackandDecker-la.com
SPECIFICATIONS
Power
No-Load Speed
Chuck
Torque
BATTERY
Voltage
Battery type
CHARGER
Input
AR
B2C
B3
BR
Output
Charging Time
* Maximum initial battery pack voltage (Measured without
a workload) is 12 volts. Measured under a workload,
nominal voltage is 10.8.
LD112
12V max*
0-600 rpm
10mm (3/8")
100 in-lbs
LB12
12V max*
Lithium Ion
LCS12
0.100A
220V ~ 50Hz
220V ~ 50Hz
120V ~ 60Hz
127V/220V ~ 60Hz
0.330A
3-5 hours

Publicidad

Tabla de contenido
loading

Tabla de contenido