Control Elements - LD Systems LAX12DA Manual De Usuario

MONO CHANNELS (MIC/LINE)
1
microphones and other low-level equipment. In addition, there are 6.3
(e.g., synthesizers, drum computers, effects processors, etc.). Synthesizer,
and LINE inputs cannot be used simultaneously on the same channel. +48V
phantom power for condenser microphones. Important: Never connect a
MONO CHANNELS: INSERT
2
the respective channel. The signal is sent immediately after the input gain
limiter. Once the signal has passed through the external signal processor, it
ting external devices to insert points requires a so-called "Y" cable.
INPUT GAIN ADJUSTMENT
3
The input gain control has two different scales: one for microphones and one
so that the peak LED above the channel fader lights up only occasionally. If
the LED is on constantly, this can lead to distortion.
LOW CUT FILTER
4
reducing low-frequency noise such as mains hum or handling noises from
vocal microphones.
STEREO CHANNELS
5
input connectors. Mono signal sources should be connected to the left jack
input connector.

CONTROL ELEMENTS:

1
2
-
3
+15dB
4
LINE IN 11/12
5
6
MIC 1
BAL OR
UNBAL
LINE IN 1
1
INSERT
-25dB LINE
0dB 40dB MIC
LEFT(MONO)
RIGHT
+4dBu
-10dBV
7