Presentation; Dm 230 - Youngman Richardson & Co DM 230 Manual De Instrucciones

DM 230

It is our wish that you will be satisfied with your product and
that it will be your companion for a long time. Think of this
operator's manual as a valuable document. By following its'
content (using, service, maintenance etc) the life span and
the second-hand value of the machine can be extended. If
you will sell this machine, make sure that the buyer will get the
operator's manual.
A purchase of one of our products gives you access to
professional help with repairs and services. If the retailer who
sells your machine is not one of our authorised dealers, ask
him for the address of your nearest service workshop.
Husqvarna Construction Products has a policy of continuous
product development. Husqvarna reserves the right to modify
the design and appearance of products without prior notice
and without further obligation introduce design modifications.
• The DM 230 is an electric handheld drill, intended for
drilling concrete, brick and various stone materials.
• The drilling machine has a modular design and is easy to
assemble.
• The machine is equipped with spirit levels to facilitate
drilling and a swivel handle with an integrated adapter for
support pins to make the work more comfortable.
• DM 230 has three speed ranges for drill bit sizes up to 150
mm.
• The machine has a water cooled gearbox with a pipe that
runs through the spindle.
• DM 230 can also be connected to a vacuum cleaner with
the help of an adapter, used for dry drilling, which is
attached to the spindle.
• The drilling machine is equipped with Softstart
TM TM
Smartstart , Elgard
Softstart™
TM
Softstart is an electronic power limitation, making it easier
to start the drill. Maximum speed is reached in about three
seconds after the power switch is pressed in.
10 –
English

PRESENTATION

TM
,
and speed control.
TM
Smartstart
TM
If the Smartstart button is pressed in directly after the
power switch is pressed in, the speed is reduced by 50%. In
TM
Smartstart mode the machine has less power until the
button is pressed in again. These functions are of great use
for creating a pilot hole for drilling.
Elgard™
TM
Elgard is an electronic overload protection.
If the motor is overloaded, the overload protection pulses the
motor. Reduce the load and the motor returns to its normal
speed. The overload protection disconnects the power, if the
machine is subjected to heavy loads or if the drill bit jams. The
machine is reset by first releasing the power switch and then
pressing it in again. If the drill bit jams, the mechanical slip
clutch protects the gearbox before the overload protection
disconnects the power.
Speed control
Speed control always gives maximum output power from the
machine. The speed control function provides the machine
with a limited idling speed.
Ergonomics
The soft rear section on the DM 230 has a large contact area
so that the machine sits better against the body. The rounded
handle makes the machine comfortable to hold while drilling.
The protective loop forms a practical carry handle when
transporting.