Important Safety Instructions; General Installation Conditions - Televes OMNI-NOVA BOSS Manual De Instrucciones

EN

Important safety instructions

General installation conditions:

• Before handling or connecting the equipment,
please read carefully all warnings and instructions
in this manual.
• In order to reduce the risk of fire or electric
shock, do not expose the equipment to rain or in
excessively moisture conditions.
• Do not take the cover off the equipment without
disconnecting it from the mains.
• Do not obstruct the equipment's ventilation
system.
• Please allow air circulation around the equip-
ment.
• The equipment must not come into contact with
water or even be splashed by liquids. Do not place
containers with water on or near the equipment if
it is not adequately protected.
• Do not place the equipment near heat sources,
like radiators, stoves, heaters or other electronic
equipment.
• Do not place the equipment where it may be
affected by strong vibrations or knocks.
How to use the equipment safely:
• If any liquid or object falls inside the equipment,
please contact a specialized technician.
• The powering voltage of this product can be
11-16Vdc, supplied by power supply or batery
feeder.
• To disconnect the equipment from the mains,
pull from the plug, and never pull from the cable.
• Do not connect the equipment to the mains until
all the other connections have been made.
• The mains socket that is going to be used to
connect the equipment should be located nearby
and should be easily accessible.
• Make sure that all power cords, plugs and cables
are not pinched or bent sharply to prevent any
possibility of damage, electrical shock or fire.
• To disconnect the equipment from the mains,
pull from the plug, and never pull from the cable.
• Do not use liquid, solvent or aerosol cleaners
to clean the equipment, and do not attempt to
clean this equipment without first unplugging it.
Description of the electrical safety
symbols:
• To avoid the risk of electric shock, do
not open the equipment.
• This symbol indicates that the
equipment complies with the safety
requirements for class II equipment.
• This symbol indicates that the
equipment complies
requirements of CE mark.
5
with the