LEMAN LOSAE250 Manual De Instrucciones página 20

2. Mounting the wheels (Fig 7)
- Push the wheels support (11) onto the lower pipe (12) until the stop.
- Screw one screw M4x18 (15) in and tighten.
3. Installing the collection bag (Fig 8 to 11)
- Fit the nozzle (16) onto the housing connection (Fig 8).
- Screw two screws M4x18 (15) in and tighten.
- Push the vacuum bag adaptor onto the nozzle (16) and press until the catches on both sides engage (Fig 9).
- Hook the vacuum bag onto the back and front fastening hooks (Fig 10 & 11).
4. Installing the shoulder strap (Fig 12)
- Open the retaining hook and hook onto the fastening eye behind the front handle and close again.
- Pull the shoulder strap over your head, adopt the work position, and adjust the shoulder strap to your height.
CAUTION:
The machine may only be put into operation if there are no defects. If a part is defective, it must be replaced before
the machine is used again.
1. Before operating (Fig 13)
- Check the safety equipment and make sure the machine is safe for operation.
- Check to make sure all parts are secure.
- Check to see if there are any visible defects: broken parts, cracks, etc.
- Check that the collection bag has been clipped into place correctly and that its zip is closed.
- Attach the connection cable to the cable grip (8) (Fig 13). Do not use the machine unless the power cord is
attached to the cable grip.
- First connect the power cord to the unit plug, and then insert into a 230 V socket.
- Put on the shoulder strap already adjusted to your height.
2. Selecting the function (Fig 14)
Even if it is possible to switch between vacuum and blow function while the engine is running, it is highly
recommended to switch the operating mode when the machine if off.
- Turn the selector lever (2), and ensure that it engages with the corresponding symbol. Never move the selector
lever to an intermediate position.
- Move the selector lever (2) to the symbol
- Move the selector lever (2) to the symbol
3. Selecting the speed (Fig 15)
This machine is equipped with a built-in electronic control circuit that can adjust and regulate the speed.
- Adjust the speed with the adjuster knob (4), depending upon the contents of operation: this can be done even
while the machine is running.
The dial is marked from the lowest speed MIN to full speed MAX, and it can be turned only as far as full speed
MAX and lowest speed MIN. Do not force to pass full speed or lowest speed, or the speed adjusting function may
no longer work.
- Always use the lowest speed when starting the machine. Then adjust by increasing the working speed.
NOTE:
- If the machine is operated at low speeds for a long period of time, run the machine at the fastest speed MAX for
few ten seconds when the work is finished in order to cool down the motor.
- If the machine is operated continuously at low speeds for a long period of time, the operation life of the motor will
be reduced.
4. Switching On and Off (Fig 15)
CAUTION: Before starting the machine, make sure that the unit is not pointing at persons, animals, objects or litter.
- To start the machine, press the trigger switch (6) and keep it pressed.
GB
OPERATION
for vacuum function.
for blowing function.
20