Fisher Scientific 850 Homogenizer Manual Del Usuario página 4

Cross Rod
Port
1. Assemble the stand (sold separately).
2. Insert the cross rod into the cross rod
port at the back of the unit and tighten
thumb screw by turning clockwise
until tight.
3. Loosen the second knob on the post
clamp and insert the cross rod with
motor attached (approximately 1"
of the cross rod should protrude from
the back of the post clamp).
Lock in place.
Stand Mounting
Cross Rod
Thumb Screw
Clamp
Stand
Cat.No 15340172
(sold separately)
1"