Gateway 2000 VIVITRON 700 Manual De Instrucciones página 24

Note: Compass orienta-
tion can affect monitor
performance. All monitors
that use cathode ray tube
(CRT) technology are sus-
ceptible to the earthﾕs
magnetic properties and
are thus affected by the
compass orientation at
which they are located.
T h o r o u g h d e g a u s s i n g
should eliminate most ef-
fects caused by the earthﾕs
magnetism.
Image is not sized or centered properly
Image cannot be adjusted full screen (to the bezel edge)
Non-shielded speakers are too close to the moni-
tor.
Strong magnetic fields are in proximity to the moni-
tor.
Your monitor is positioned too close to another
monitor or a metal shelf or metal support.
Compass orientation of the monitor.
The monitor has an auto-degauss function that auto-
matically demagnetizes the metal frame in the cathode
ray tube (CRT). This function is triggered when you
power up the monitor. Sometimes more than one de-
gauss cycle is required to eliminate magnetizing ef-
fects. If this is the case, initiate the auto-degauss pro-
cess several times (by powering the monitor up and
down) at intervals of more than 20 minutes each.
Use the size and center controls to adjust the image as
desired. See the section of this manual entitled, "Screen
controls and functions."
Some video modes used by your monitor produce
images that cannot be adjusted all the way out to the
bezel edge (the edge where the screen glass and moni-
tor casing plastic meet). This condition does NOT indi-
cate that the monitor is defective. Choose a different
refresh rate or resolution.
Userﾕs Guide 23