Milwaukee PJ 710 Instrucciones De Uso página 7

On-/off switch
Adjusting the
cutting depth
Adjusting the
angle setting
Maintenance
Accessories
ENGLISH
Switching on:
Slide back the On/Off switch. To lock,
depress the front part of the sliding switch.
Switching off:
To unlock, depress the back part of the
sliding switch. The switch will automatically
move back to "0".
After exchanging the blades the cutting depth should be checked and adjusted, if
necessary.
1.
Set the cutting depth adjusting knob to the
Max position.
2.
Push the motor part forward as far as it will
go and turn the blade until one tooth has
reached the front position.
3.
Measure the distance from the edge of the
base plate to the cutting tooth; it must be 19
mm in the Max position.
4.
In order to correct the cutting depth, loosen
the counter nut and turn the set screw as
required. (1 rotation = 0.7 mm) Re–tighten
the counter nut.
1.
Set the swivel fence to 0
Loosen the screw  and move the
2.
marking
until it faces the 0-setting of the
swivel fence. Re-tighten the screw.
The ventilation slots of the machine must be kept clear at all times.
Use only Milwaukee accessories and spare parts. Should components need to be
exchanged which have not been described, please contact one of our Milwaukee
service agents (see our list of guarantee/service addresses).
If needed, an exploded view of the tool can be ordered. Please state the ten–digit
No. as well as the machine type printed on the label and order the drawing at your
local service agents or directly at: Atlas Copco Electric Tools GmbH, Postfach 320,
D–71361 Winnenden.
The range of accessories with part numbers is shown in our catalogue.
6
1 9 m m
o
.
1
2
1 2
PJ 710