Product Overview; Alarm Unit; Door Sensor; Remote Control - CPVan CP3 Manual De Usuario

Product Overview

A
B
C
E
D

Alarm unit

A. Siren/Chime Integrated
B. Visual Indicator for 4 different zones
C. 30 seconds Exit delay /
D. Arm Button
E. Switch Voice / Switch from Siren to Chime vice versa
Door & window sensor
A
B
A. Sensor
The sensor contains the electronic detection system for the magnet. If the magnet
is separated from the sensor, a wireless signal is sent to the Alarm unit. The Alarm
unit will then transmit an audible signal (alarm).

Remote Control

A. Bell button：triggers a loud emergency alarm
B. Delay button：30 seconds delay Exit
C. Arm button：activate the Alarm unit
D. Disarm：deactivate the Alarm unit
E
C
B. Magnet

First preparation of the Alarm unit

Remove the back cover, take out the 2 AAA batteries and the insulating strip in the
Alarm unit and close the lid. You will hear a beep and the indicator light on the
Alarm unit will light. Your Alarm unit is now active.
Take out the insulating strip in each Door sensor (inside Lithium battery).
Please note the correct orientation of the batteries (+ /-).

Pressing the buttons

IMPORTANT: There are 2 ways to press the buttons on your Alarm unit:
. Short press: press the button for 1 second or less.
. Long press: keep the button pressed for 5 seconds.
Usually, the long press of 5 seconds is used to enter a programming or pairing mode.
This procedure prevents that important settings are changed accidentally.

Using the Alarm unit

The alarm unit can be operated both through the remote control as well as by
switching the buttons on the side.
Switch : Home working mode which means when detector is triggered, it will alarm
immediately. when the unit is switched
Switch : 30 seconds delay mode. The alarm unit will be activated after 30 seconds.
when the unit is switched and a beep will be heard.
Arm/Disarm: Make sure the Alarm unit is switched on. Now, short press the Arm
button once. A beep will be heard and the visual indicator will light up once when
the unit is armed, and input the 4 digital correct code (the default code is 1234), 2
beeps will be heard and the visual indicator will light up twice if the unit is disarmed.
IMPORTANT: Your Alarm unit is equipped with a memory function. This means that
the Alarm unit will always come back to its last settings when switched on. If it was
armed when it was switched off, it will be armed when it is switched On again.
However, if it was disarmed when it was switched Off, it will be disarmed when
switched On again. In this case, to arm the Alarm unit just short press the Arm
button [ ] .
Change the sound: Make sure the Alarm unit is switched on. Toggle Change the
between sounds by slide the Button [
heard if the sound is changed.
Entering the Pairing mode: Make sure the Alarm unit is switched On. Long press the
one of four digital button. The opposite light on the front of the Alarm unit are now lit.
See the Chapter "Pairing with sensors and remote controls" for further instructions on
how to pair devices with the Alarm unit.
and a beep will be heard.
/ ] . A short confirmation sound will be