Using The Device; Application Areas - Medel DERMO PEEL Instrucciones De Uso

Note
The device can also be used twice a week for non-sensitive problem skin (with a break
of at least 48 hours between use).

6.2 Using the device

1. Connect the mains adapter to the
device and plug the adapter into the
socket.
2. Insert a single-use filter into the head
of the device.
3. Place the attachment you wish to use
on the tip of the hand-held device.
4. To switch on the device, move the
ON/OFF switch to the desired inten-
sity level.
5. Place the hand-held device on your
face and move it over the skin. Make
sure that you do not move the hand-
held device over one part of the face
more than once. Further details on
treatment can be found in Section "6.3

Application areas".

100131_MEDEL BD DERMO PEEL 95159_USER MANUAL_REV.01_05.06.2017.indd 18-19
18
Note
The pressure you apply when using the device should be comfortable and
not painful. Some slight reddening should be expected after use.
6. When you have completed the appli-
cation, switch off the device using the
ON/OFF switch and disconnect the
mains adapter from the socket..
7. Change the single-use filter after each
use. To do this, pull the attachment off
from the top. Use tweezers to remove
the single-use filter.
6.3 Application areas
Note
Ensure that the part of your face you are treating is taut when you move the
hand-held device over the skin. You can do this by pulling the skin taut to the side
or downwards with your free hand.
Forehead:
Move the hand-held device slowly and evenly outwards from
the centre of the forehead. Make sure that you do not treat
any part of your skin more than once.
Temples:
Move the hand-held device outwards towards your hairline.
Repeat this to the left and right of the nose. Ensure that the
device is at least 1 cm away from your eyes.
19
05/06/2017 14:06:38