Usage - Warning - Quick EAGLE Serie Manual Del Usuario

WARNING: stay clear of the chains, ropes and gypsy. Make sure the electric motor is off when windlass is used manual-
ly (even when using the handle to disengage the clutch). In fact people with windlass remote controls (hand-held remote
control or radio-controlled systems) might accidentally operate it.
WARNING: secure the chain with a device before starting the navigation.
WARNING: do not operate the windlass by using the electrical power when the handle is inserted in the drum or into
the gypsy cover.
WARNING: Quick ®
magnetic or hydraulic-magnetic) to protect the motor supply line from overheating or short circuits. The circuit breaker
can be used to cut off power to the windlass control circuit and so avoid accidental activation.
CLUTCH USE
The clutch (3) provides a link between the gypsy and the main shaft (17). The clutch can be released (disengagement) by using
the handle (1) which, when inserted in the gypsy cover (2), must be turned counter-clockwise. The clutch will be re-engaged by
turning it clockwise (engagement).
WEIGHING THE ANCHOR
Turn on the engine. Make sure the clutch is engaged and remove the handle. Press the UP button on the control provided. If the
windlass stops and the hydraulic magnetic switch (or thermal cutout) has not tripped, wait a few seconds and try again (avoid
keeping the button pressed). If the hydraulic magnetic switch, has tripped, reset it and wait a few minutes before weighing
anchor once again. If, after a number of attempts, the windlass is still blocked, we suggest to move the boat to release the
anchor. Check the upward movement of the chain for the last few meters in order to avoid damages to the bow.
CASTING THE ANCHOR
The anchor can be cast by using the electrical control or manually. To operate manually, the clutch must be disengaged allowing
the gypsy to revolve and letting the rope or chain fall into the water. To slow down the chain, the handle must be turned clock-
wise. To cast the anchor by using the electrical power, press the DOWN button on the control provided. In this manner, anchor
casting is under control and the chain unwind evenly. In order to avoid any stress on the windlass -once the boat is anchored-
fasten the chain or secure it in place with a rope.
DRUM USE
WARNING: before carrying out warping operations, check that the anchor and relative chain are solidly fixed to a bitt or
another strong point on the boat.
For the independent use of the drum (21) release the clutch with the handle (1), (at least 2 turns of the gypsy
cover anticlockwise). Remove the handle from the gypsy cover (2), wrap the rope around the drum (at least 3 turns).
WARNING: during take up maintain a safe distance between hands and windlass drum.
Once take up is complete, screw up the clutch by tightening the gypsy cover clockwise and secure the rope to a bitt or other
strong point on the boat.
EAGLE 700/1000/1400W - REV009A
recommend using a circuit breaker designed for direct current (DC) with delayed-action (thermal-

USAGE - WARNING

GB
13