Migatronic MigADCplus Manual De Instrucciones página 5

► WARRANTY
The warranty period of MIGATRONIC products is three years. Failure to follow these
instructions may invalidate the warranty. MIGATRONIC does not accept responsibility
for any problems which may arise from applications other than welding.
► MigADCplus HELMET AND HEADGEAR ASSEMBLY
1. Insert screws (A) through the openings in the headgear (D).
2. Insert the headgear (D) into the helmet shell (F) as shown in figure 1 and push the
screws (A) through the rectangular openings in the helmet shell.
3. Put the tilt adjustment (B) on the right side between the screw (A) and helmet shell
(F). Make sure that a small pin is fixed in one of the three holes in the helmet shell.
Choose the right hole for your maximum comfort.
4. Tighten the nuts (C) on the screws (A). Before adequately tightening them, place the
headgear at the most comfortable distance from the filter opening by adjusting the
possition of headgear within the two rectangular holes in the helmet shell.
5. The headgear size (D) can be adjusted by turning the rear wheel (E) in order to fit any
head size. Press the wheel and hold it while turning, release the wheel when reaching
the position of maximum comfort, so that it will lock in the required position.
The headgear is equipped with a replaceable sweatband. Sweatbands are available
through your local dealer.
► MigADCplus HELMET AND HARD HAT ASSEMBLY
/ MigADCplus HH - version of MigADCplus helmet with Safety cap concept /
B.1
Figure
If you have purchased the MigADCplus welding helmet in combination with hard
hat, a two part (left and right) hard hat adaptor will be replacing the standard
headgear. Each of the two hard hat adaptor parts are clearly marked with L (left)
and R (right) on the main body. Please choose the right one for each side.
1. While pressing the screw with your index finger, loosen the nut, as shown on figure 1.
2. Push the screw through rectangular opening in the helmet shell, while still holding the
screw. Put the pin for the tilt adjustment in one of the three holes in the helmet shell.
Choose the right tilt adjustment hole for your maximum comfort (2.).
3. Tighten the nut on the screw (3.).
4. Repeat the assembly of the hard hat adaptor on the opposite side of the helmet.
5. Insert the wedges of the hard hat adaptor into the hard hat slots. Make sure that the
lower latches of the hard hat adaptor have stuck over the edges of the hard hat (5.).
6. The headgear of the hard hat can be adjusted by turning the rear wheel in order to
fit any head size. Press the wheel and hold it while turning, release the wheel when
reaching the position of maximum comfort, so that it will lock in the required position (6.).
7. The two springs of the hard hat adaptor hold the helmet in two extreme positions: up
and down (7.).
The headgear is equipped with a replaceable sweatband. Sweatbands are avail-
able through your local dealer.
► AUTODARKENING WELDING FILTER AND PROTECTION
LENS ASSEMBLY
1. Slide in the inner protection lens on the inner side of the autodarkening welding filter
as shown in figure (1.).
2. Gently fold the printed circuit board of the external control behind the filter so that it is
positioned inside the helmet shell before you. Insert the filter in its opening. Begin by
inserting the filter at the bottom, so that it clicks in the bottom clip (2.a); then push in
the top part so that it clicks into the top clip (2.b).
3. Insert the external protection lens into its position with four side holders. Hold the
protection lens with your thumb and middle finger and place it on the side of your
thumb into the slots of both side holders. The indent of the helmet shell provides the
4
/ MigADCplus ADF /
A
Figure
B
Figure
C
Figure