Limitations On Use - Migatronic MigADCplus Manual De Instrucciones

necessary space for your thumb (3.a). With your middle finger bend the protection lens
and with the aid of the other fingers place it in both side slots (3.b).
4. Close the helmet shell with the external frame. Insert the bottom two pins in the lowest
two openings of the helmet shell and push the top part of the frame into the helmet shell
so that the two upper pins click in the pin openings on both sides (2x click) (4.).
5. Insert the middle part of the external control housing in its opening on the exterior
side of the helmet shell (5.).
6. Insert the electronic circuit board with potentiometers in the middle part of the external
control housing (6.).
7. While pressing the electronic board, insert the 4 knobs to the potentiometers from the
outside. Take care, that the knobs are inserted correctly. Check that the final position of
the marks on the knob correspond to the printing on the external controls housing (7.).
8. Insert the external part of the external control housing so that it fits on the middle part
of the external control housing (8.).
9. Place the internal part of the external control housing correctly on the middle part of
the external control housing and fix it with four screws (9.).
C.1
Figure
In case an automatic filter needs to be removed from the bearing (e.g. due to the
changing of the inner protection foil), first release the loop on the connecting electrical
cable, as shown in Figure 10, and remove the filter. When inserting the filter back
into the bearing, place the cable and the loop as shown in Figure 11.a (MigADCplus)
and 11.b (MigADCplus-Air). The extended electrical cable is required to prevent
considerable overload and consequential cable tear while displacing the filter.
► PROTECTION LENS REPLACEMENT
1. Remove the external frame. From the internal side of the helmet shell squeeze the two
pins towards each other, release the frame and slightly push it out (1.a), then rotate it
to release the bottom two pins (1.b).
2. Hold the protection lens with your thumb and middle finger on the side extensions
along the indents in the helmet shell intended for your fingers. Press on the protection
lens to slightly bend it and remove it from the holder slots (2.).
3. Insert a new protection lens and close the cover as described in the previous section,
under points 3 and 4.
D.1
Figure
During assembly of the helmet and welding filter, or during the replacement of
the protection lens, make sure that all parts are firmly in place thus preventing
any light from entering the helmet. Should there still be any light entering, re-
peat the procedure until the problem is eliminated, otherwise the helmet must
not be used for welding. Before placing the new protection lens, always remove
the protection layers from both sides.
► MigADCplus-Air HELMET ASSEMBLY
/ MigADCplus-Air - version of MigADCplus helmet with integrated
air supply system for combination with CleanAIR Power unit set /
If you have purchased the MigADCplus helmet in a combination with the integrated
air supply system, the helmet will be additionaly equiped with integrated airduct,
hose connector and air grill. MIGATRONIC does not except responsibility for the
results of a service performed by anyone other than a MIGATRONIC authorised
service agent. Failure to follow this instructions may invalidate the warranty.
►

LIMITATIONS ON USE

1. Material of the hood can cause allergic reactions to a sensitive person.
2. Do not use tempered mineral filters without suitable protection foils.
3. The welding arc damages unprotected eyes!
4. The welding arc may burn unprotected skin!
5. Pay attention to checking the product before use. Do not use, if any part of the
system is damaged.
D
Figure
E
Figure
5