Safety Measures And Requirements; Instructions For Use - FAR FHU 05 Instrucciones De Uso

FHU 05

INSTRUCTIONS FOR USE

INDEX
GUARANTEE ............................................................................... 7

SAFETY MEASURES AND REQUIREMENTS ................................ 7

MAIN COMPONENTS .................................................................. 8
TECHNICAL DATA ....................................................................... 8
TOOPING UP THE OIL-DYNAMIC CIRCUIT ................................. 9
DEVICE DISPOSAL ...................................................................... 9
GUARANTEE
FAR riveting tools are covered by a 12-month warranty. The
tool warranty period starts on the date of delivery to the
buyer, as specified in the relevant document. The warranty
covers the user/buyer provided that the tool is purchased
through an authorized dealer and only if it is used for the
purposes for which it was conceived. The warranty shall
not be valid if the tool is not used or maintained as specified
in the instruction and maintenance handbook. In the event
of defects or failures, FAR S.r.l. shall undertake solely to
repair and/or replace the components it judges to be faulty.
SAFETY MEASURES AND REQUIREMENTS
WARNING!
All the operations must be done in conformity
with the safety requirements, in order to avoid
any consequence for your and other people's
security and to allow the best tool work way.
• Read the instructions carefully before using the tool.
• For all maintenance and/or repairs please contact FAR
s.r.l. authorized service centers and use only original
spare parts. FAR s.r.l. may not be held liable for
damages from defective parts caused by failure to
obser ve what above mentioned (EEC directive
85/374).
The list of the service centres is available on our website
http://www.far.bo.it ( Organization )
• The device must be used only by expert workers.
• A protective visor and gloves must be put on when using
the device.
• For topping up the oil, we suggest using only fluids in
accordance with the features specified in this working book.
• If any drop of oil touches your skin, you must wash with
water and alkaline soap.
• The device can be carried and we suggest putting it into its
box after using.
• The device needs a thorough six-monthly overhaul.
• Repairing and cleaning operations must be done when the
device is not fed.
• If it is possible, we suggest a safety balancer.
Revisione - 05
I
GB
• If the A-weighted emission sound pressure level is more than
70 dB (A), you must use some hearing protections (anti-noise
headset, etc.).
• The workbench and the work surface must be always clean
and tidy. The untidy can cause damages to people.
• Do not allow unauthorized persons to use the working device.
• Make you sure that the compressed air feeding hoses have
the correct size to be used.
• Do not carry the connected device by pulling the hose.
• Keep the device in good conditions; do not remove either
safety parts or silencers.
• After repairing and/or adjusting, make sure you have already
removed the adjusting spanners.
• Before disconnecting the compressed air hose from the
device make sure that there is no pressure in the hose.
• These instructions must be carefully followed.
WARNING!
Before using the device, assemble the protection bottom
supplied with the tool, as indicated in the picture on side.
FAR has no responsibility for any damages on the device,
persons or things caused by lack of the protection bottom.
Date 01-2012 7