Beper 50.001 Manual De Instrucciones página 9

EN
Steam station Use instructions
Before cleaning, always unplug the appliance.
To protect against electric shock, do not immerse cord, plug or any
parts of the appliance into water or other fluids.
Do not hold the appliance with wet hands or feet.
Do not hold the appliance with naked feet.
Do not expose the appliance to atmospheric agents such as rain,
wind, snow, hail.
Do not use the appliance near explosives, highly flammable mate-
rials, gases, burning flames, heaters.
Do not allow children, disabled people or every people without expe-
rience or technical ability to use the appliance if they are not properly
watched over. Close supervision is necessary when any appliance
used by or near children.
Make sure that children do not play with this appliance.
If you decide not to use the appliance any longer, make it unservice-
able by simply cutting the supply cable after disconnecting the plug
from the socket.
ALSO MAKE ANY DANGEROUS PARTS UNSERVICE-
ABLE, ESPECIALLY FOR CHILDREN WHO COULD
PLAY WITH THE APPLIANCE.
PARTS AND ACCESSORIES Fig.A
1. Iron base
2. Iron connection cable (supply cable + steam hose)
3. Power cable
4. Boiler on/off switch
5. "Steam ready" light
6. Iron on/off switch
7. Boiler safety cap
8. Tank
9. Thermostat knob
10. Steam and continuous steam button
11. Thermostat light
INSTRUCTIONS FOR USE:
IRONING:
NOTE: Iron only on heat-resistant surfaces that allow heat to escape (grid).
Make sure that the safety cap is tightly closed, otherwise some steam escapes. The "steam ready" light turns
on and off during use, this fact is normal and indicates that the machine keeps the steam pressure constant.
When using the iron for the first time, it is recommended to clean the iron with a clean cloth (without any deter-
gent).
Fill the tank with water.
Press the iron switch and the boiler switch to turn the appliance on in "steam ironing" mode.
9