BST MX62BT-DSP Manual De Instrucciones página 5

QUICK GUIDE
1. Be sure that your mixer is turned off and that all level controls are turned all the way down.
2. Turn off any other external devices, and then connect microphones, line level devices, instruments and speakers.
3. To avoid damage to your speakers, power up the devices in the following order:
Peripheral devices→ mixer→power amps or powered speakers. Reverse this order when turning power off.
NOTE: If you are using a condenser microphone that requires phantom power, turn the phantom power switch (6)
on before turning on the power to the power amp or powered speakers.
4. Adjust the channel GAIN controls so that the corresponding CLIP indicators flash briefly on the highest peak levels.
5. Set the MAIN MIX control (34) to the "MIN" position.
6. Set the Channel gain controls to create the desired initial balance, then adjust the overall volume using the
STEREO OUT Master fader.
If the CLIP indicator lights frequently, lower the Channel controls a little to avoid distortion
BLUETOOTH PAIRING PROCEDURE
Select the BLUETOOTH input by pressing the button (27) into the lower position. Press the Bluetooth button (30). The
Bluetooth LED (31) lights up steadily in blue. Activate the search for Bluetooth devices on your smartphone. Select
"Bluetooth" in the list of found devices. When both units are paired successfully, the Bluetooth LED (31) flashes
continuously in blue. Set the volume via the USB/BT level control (29). The DSP effects cannot be applied to the
Bluetooth signal.
SPECIFICATIONS
INPUTS:
DJ MIC ........................................................................................... 1.5mv/1K Ohm balanced
LINE ............................................................................................................ 150mv/27K Ohm
OUTPUTS:
MASTER ............................................................................................................. 1V/5K6 Ohm
GENERAL:
Frequency Response ............................................................................ 20Hz-20KHz @ ±2dB
THD ................................................................................................................................ 0.1%
S/N Ratio ................................................................................................................... >80 d B
Headphone Impedance ............................................................................................ 32 Ohm
Power supply ......................... 100-240Vac 50/60Hz via 12Vdc 1A mains adaptor (supplied)
Dimensions ...................................................................................................... 22 x 17 x 6cm
Weight ....................................................................................................................... 1.090kg
Electric products must not be put into household waste. Please bring them to a recycling centre.
Ask your local authorities or your dealer about the way to proceed.
©Copyright LOTRONIC 2017 MX62BT-DSP 5