Daga AC-2000 Instrucciones De Uso página 11

Masajeador corporal anticelulítico
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

ENGLISH
INSTRUCTIONS FOR USE
Prior to plugging the product into the mains, check that your mains
voltage is the same as or is within the limits indicated on the pro-
duct label. The safety instructions marked at the beginning of this
manual must be followed at all times when using this product.
Follow the instructions below in order to switch on the appliance:
1. Remove the product from its original packaging taking special
care not to damage any of its parts. Do not use excessive force to
remove the product from the box.
2. Fit the head you wish to use according to the type of treatment
you wish to carry out.
3. You can attach the head-cover mesh Bear in mind that the cover
must not be used with some heads. See the instructions in this
manual to check with which heads it can be used.
4. Connect the appliance to the mains.
5. Turn the speed selector clockwise towards the ON position to
turn the device on. As you turn the dial you will see the turning
speed of the head increase. The product should always be used at
low intensity at the start, increasing the intensity as necessary.
6. Apply the treatment on the desired areas, always observing the
safety instructions given in this manual.
7. When using the massager, the infrared heat function is automati-
cally activated to intensify the treatment, accelerating the elimina-
tion of fat and regulating local microcirculation.
8. When you wish to finish the anti-cellulite massage session just
turn off the device by turning the dial towards the OFF position
(anti-clockwise), disconnect it from the mains, remove the used
head and store all the equipment in its original packaging.
The duration of each session is 15 minutes. When this time has
passed you should turn off the device and leave it to rest to avoid
overheating of the product and to not overload the treated areas.
After 15 minutes rest, you may use the device again.
Heads:
1. Smooth head: designed for a relaxing treatment through a uniform
and even contact surface that strengthens the sensation of calm
and wellbeing without being too intense.
2. Exfoliating heads: Ideal for exfoliating the skin by eliminating
dead cells.
3. Fabric head-cover accessory: This complement can be used with
the flat (1) or corrugated (4) head. It must not be used with the
other two heads. It must be used around the areas where there is a
danger of the device tangling with hairs (e.g. the shoulders).
4. Corrugated head: generates an intense massage ideal for anti-ce-
llulite treatment on the upper area of the legs, glutes and abdomen.
5. Head with lipoactive massage balls: the effect of this head favours
the displacement of the device over your body and generates a
sensation of continuity and fluidity, giving an efficient lipoactive
massage.
11

Publicidad

Tabla de contenido
loading

Tabla de contenido