Pur Line CHE-490 Manual De Usuario página 15

OPERATION
After reading complete instructions, confirm all controls on fireplace are in the OFF position.
Plug the fireplace into a 15AMP/220V outlet.
WARNING: The machine will turn off automatically when the temperature drops suddenly by 5-10ºC, the
corresponding indicator light
DISPLAY
CONTROL PANEL
The controls are located at the bottom of the fireplace. It takes some time for the receiver to respond to the
transmitter. Do not PRESS the buttons more than once within two seconds for correct operation.
+
ON/OFF
HEAT TIMER
MAIN SWITCH:
ON(I). Enable all functions
OFF(O).Turn off all functions on control panel and remote control.
ON/OFF:
Press this button once, flame is turn on. The unit is turn on and you can select the functions as desired.
Press this button again to turn off the device.
TIMER: Press this button set up time from 0.5H to 12H.
FLAME: Press this button to set flame brightness in 4 levels.
HEAT:
Two settings. Press one time for low heat, press two times for high heat, press again to turn heating off,
and fan will continue working for 10 seconds.
-
: Increase Temperature setting. Press this button to set temperature from 15-36ºC. Each press will increase
temperature by 1ºC.
+
: Reduce Temperature. Press this button to set temperature from 36-15ºC. Each press will reduce
temperature by 1ºC.
will light on (when window is opened).
-
FLAME
EN
ON/OFF
HEAT I
HEAT II
TEMPERATURE
DAY
TIMER ON
TIMER OFF
TIME
OPEN WINDOW
DETECTION
FLAME
13
MAIN SWITCH