Cleaning And Maintenance, Changing Ir Tubes - Speedheater 1100 S Manual De Instrucciones

CLEANING AND MAINTENANCE
Always ensure the power cord is disconnected from the electric outlet and the tool is completely
cooled before beginning any cleaning or maintenance work.
In order to maintain the product's safety and efficiency, the IR tubes and reflectors must be kept clean.
The IR tubes and reflectors can be wiped using a cloth moistened with Denatured Ethanol.
Ensure that the Power Tool has completely cooled down.
Remove the safety grid by undoing screws 1 at each end.
Carefully wipe accessible parts of the tubes, reflectors and the safety grid.
Replace the grid and ensure that the screws are seated tightly.
Avoid scraping with sharp objects.
Always use protective gloves.
CHANGING IR TUBES
The IR tubes are made of quartz glass and must be handled with care. If an IR tube breaks,
immediately switch the tool off, pull the plug from the wall socket and replace the tube.
Always use gloves or a rag when handling the IR tubes. Never touch them with your hands.
Repairs should be carried out only by a properly qualified electrician to avoid the
risk of accidents or injury.
The tubes are hot during operation and take some time to cool off. Before changing any tubes, make
sure they have cooled. Always use heat-protective gloves in order to avoid burning and
cutting injuries.
When changing the IR tubes you need to secure the handle of the Power Tool firmly in a vice with a
cloth around the handle so that when you turn the plinth screws you don't move the tool.
To remove the screws for the wires you need a flat head 1/8" wide screw driver.
The wrong size screw driver will crack the ceramic plinth and/or strip the screw heads.
When reassembling, make sure not to over tighten any of the screws.
- Remove the safety grid by loosening the screws on each end 1 .
- Unscrew the safety grid 2 and the reflector flanges 3 .
- Detach the IR tube cable connections by undoing the screws on the connection plinths 4 .
16
Repairs should be carried out only by a
properly qualified electrician to avoid the
risk of accidents or injury.
2
1
3
3
Flat head 1/8" wide screw driver.
(4 mm)
1
4
4