Service Instructions; Start Conditions - CTX BIOCLEAN CONTROL Serie Manual De Instrucciones

4.3 - SERVICE INSTRUCTIONS

4.3.1 - Start conditions

a) Be sure that the working switch is in "RUN"
position. After pressed reset button "R", display
start flashing
b) If working switch in "P" position and the reset
button is pressed, on display will appear an error
message "EEE". Moving this switch on "RUN"
position, the above message will disappear.
c) If switch is moved on
will not flashing.
d) If switch is moved on "RUN" position, two points
start flashing.
e) If switch is moved on "P" position, display start
flashing
4.3.2 - Manual command
Move left switch on "1" position.
• On display will appear the "lamp" icon, the output contact will switch on closed.
Move switch on "0" position
• On display will disappear the "lamp" icon, the output contact will switch on open.
Move switch on "AUTO" position
• The function depends now by set programs
4.3.3 - Time function: setting and description
Example: set wednesday, time 15:16
Move switch on position, after that:
a) Day of week setting: pressing day button "1...7",
the arrow on the top of the display moves by 1 unit.
Keeping pressed the button more than 1 sec.,
the arrow moves by 1 unit/sec until the button is
pressed.
b) Hours and minutes setting: to obtain 15:16 press
"h" button for hours, press "m" button for minutes.
Pressing this button the values moves by 1 unit.
Keeping pressed for more than 2 sec, the value
moves quickly (8 units/sec.) until the button
is pressed.
position, display
• 21 •