Grex G4.2 Pro Kinetic N Com Seguridad E Instrucciones página 16

5.6 Remove the protective film from the PINLOCK
entire silicone-sealed profile of the inner visor adheres to the visor.
5.7 Fit the visor on the helmet (see instructions above).
Checking and Adjusting the PINLOCK
Check the correct PINLOCK
and making sure that they do not move.
If the PINLOCK inner visor is not tightly fixed to the visor, move both external adjust-
®
ment levers upwards to increase the stretch (Fig. 10). This operation must be carried
out gradually. The maximum stretch is achieved when the pin adjustment external
levers are turned outwards.
WARNING
- The presence of dust between the two visors may produce scratches on both
surfaces.
- Scratched PINLOCK
must therefore be replaced.
- Regularly check the correct stretch of the PINLOCK
from moving and scratching both surfaces.
- If the helmet visor fogs up and/or condensation forms between the visors, check
that the PINLOCK
- An excessive and early stretch of the PINLOCK
sive adherence against the visor surface and/or permanent deformations with
subsequent inability to correctly perform any following adjustments.
- Intense sweating /breathing, the use under particular weather conditions (low
temperatures, and/or high humidity and/or sudden changes in temperature and/
or heavy rain) and/or intense and prolonged use may affect the performance of
the PINLOCK
such cases, after using the helmet and to restore the system efficiency, remove
the PINLOCK
air. The same procedure must be applied to the helmet, in order to dry out humid-
ity in case it has formed up as a consequence of the conditions described above.
6. Inner Visor PINLOCK
6.1. Remove the visor equipped with the Pinlock
6.2. Widen the visor and release the Pinlock
6.3. Release the visor.
Maintenance and Cleaning
- Remove the PINLOCK
gently clean it with neutral liquid soap. Remove the soap under running water.
- Dry the inner visor with dry and warm air without wiping it.
- To keep the features of the inner visor in good conditions over time, let the helmet
dry in a ventilated and dry place with the visor open after use. Keep it away from
heat sources and store it in a place away from direct light.
- Do not use solvents or chemical products.
SIDE PLATES
(Available as standard or accessory/spare part).
When the G4.2 PRO helmet is configured without visor, assembling the side plates in
its place is recommended.
inner visor assembly by opening and closing the visor
®
visors and inner visors may cause reduced visibility and
®
inner visor is both correctly assembled and stretched.
®
inner visor and cause fogging or formation of condensation. In
®
inner visor from the helmet visor and let it dry with dry and warm
®
Disassembly
®
inner visor from the visor. Using a damp and soft cloth,
®
inner visor and check that the
®
Inner Visor Stretch
®
inner visor to prevent the it
®
inner visor may result in exces-
®
inner visor (see instructions above).
®
inner visor from the pins (Fig. 9).
®
16