Grex G4.2 Pro Kinetic N Com Seguridad E Instrucciones página 19

9. VPS Disassembly
To remove the sunscreen from the helmet, open the visor completely and lower the
VPS by pushing the slider completely upwards (Fig. 13 B).
9.1. Hold the central part of the sunscreen, press it slightly towards the inner part of
the helmet and simultaneously pull the sunscreen downwards until its upper grip
pawl has been removed from the shell (Fig. 14).
9.2. Hold the left side part of the sunscreen, push it slightly towards the inside and
then pull it towards the front of the helmet (Fig. 15). Repeat the same operation
on the right side of the helmet.
10. VPS Assembly
To remove the sunscreen, open the visor completely and push the slider completely
upwards (Fig. 13 B).
10.1. Insert the sunscreen left end into the left side guide until the grip pawl is hooked
into the shell housing (Fig. 15). Repeat the same operation on the right side of
the helmet.
10.2. Press the sunscreen slightly towards the inside of the helmet near its upper grip
pawl while pushing it in the seat between the outer and inner shells (Fig. 14).
WARNING
- Push the left side slider completely downwards (Fig. 13 A) and upwards (Fig.
13 B) to make sure that the VPS works properly. If necessary, repeat the
above-mentioned steps.
- If the VPS opening/closing mechanisms are damaged or not working properly,
please contact a Grex authorized dealer.
- Do not use the helmet if the VPS has not been assembled properly.
- Since the VPS does not assure you the same protection as the one provided by
the visor, it has to be used only when the helmet visor is lowered.
REMOVABLE INNER COMFORT PADDING
11. Inner Comfort Padding Disassembly
To remove the inner comfort padding, lift the VPS, open the visor completely
and remove the chin guard from the helmet (see instructions above).
11.1. Open the chin strap (see specific instructions) and pull the front of the left cheek
pad towards the inside of the helmet to undo the snap fastener from the left
frame (Fig. 16). Repeat the same operation on the right side of the helmet.
11.2. Release the roll neck left eyelet from the left frame (Fig. 17). Repeat the same
operation on the right side of the helmet.
11.3. Release the liner left rear flap from the support fixed to the inner polystyrene
shell by slightly deforming the shell edge and slightly pulling the comfort pad-
ding towards the inside (Fig. 18). Then repeat the same steps to remove the
central flap as well as the right flap.
11.4. Remove the left and right side flaps of the comfort padding from the cavities
between the inner polystyrene cheek pads and the outer shell inner side frames
(Fig. 19).
11.5. Hold the left front part of the liner and pull it upwards in order to remove the
corresponding liner flap from the support fixed to the polystyrene inner shell
(Fig. 20). Then repeat the same steps for the central front and right flap.
11.6. Remove the chin strap left band from the cheek pad slot (Fig. 21). Repeat the
same operation on the right side of the helmet.
19