X-LITE X-403 GT ELEGANCE N-COM Seguridad E Instrucciones página 21

cause fogging and/or formation of condensation on the VPS, which entails a
reduction of visibility and/or sharpness of vision: in this case, deactivate the
VPS.
- In case of rain, the direct contact of raindrops with the scratch resistant/fog-re-
sistant treated VPS quickly reduces sharpness of vision, thus causing scarce
visibility: in this case, deactivate the VPS.
- The special VPS fog-resistant treatment is usually sensitive to high temper-
atures or heat sources. In this case, contaminations caused by contact with
other materials might occur. These contaminations will cause marks and stains
to develop. In these cases (e.g. when the helmet is kept in the top case on hot
days), it is recommended to make sure the visor is not touching other materials.
9. VPS disassembly
To remove the sun screen from the helmet, open the visor completely and lower the
VPS by rotating the side slider completely upwards (Fig. 11B).
Hold the left side part of the sun screen and pull it toward the outside of the helmet
(Fig. 12).
Repeat the same operation on the right side of the helmet.
10. VPS assembly
To assemble the sun screen on the helmet, open the visor completely and push the
side slider completely upwards (Fig. 11B).
Insert the sun screen left end into the left side guide until the grip pawl is hooked in
the shell housing (Fig. 12).
Repeat the same operation on the right side of the helmet.
WARNING
- Make sure that the VPS operates correctly by moving the left side slider down-
wards (Fig. 11A) and upwards (Fig. 11B) until you hear the clicks meaning that
it has entered the relevant positions. If necessary, repeat the above-mentioned
steps.
- If the VPS opening/closing mechanisms are not working properly or if such
mechanisms get damaged, please contact an X-Lite authorized dealer.
- Do not use the helmet if the VPS has not been assembled properly.
- Since the VPS does not assure you the same protection as the one provided by
the visor, it has to be used only when the helmet visor is lowered.
REMOVABLE INNER COMFORT PADDING
To remove the inner comfort padding, lift the VPS, open the visor completely and
remove the helmet chin guard (see instructions above).
11. Cheek pad disassembly
11.1. Open the chin strap (see specific instructions) and remove the chin strap band
from the elastic loops on the strap and on the roll neck (Fig. 13).
21