Nolan N100-5 Special N-Com Seguridad E Instrucciones página 24

N100-5 / PLUS
3 DISASSEMBLY OF THE ROLL NECK
To remove the roll neck, follow the instructions below after removing the cheek pads
from the helmet (see instructions above).
3.1 Pull the roll neck towards the inside of the helmet to release the front button from
the lining of the inner polystyrene cheek pad (Fig.18).
3.2 Pull towards the outside of the helmet to remove the side flap from the seat on the
lining of the inner polystyrene cheek pad (Fig.19).
3.3 Follow the same steps on the other side of the helmet.
3.4 Pull the roll neck towards the inside of the helmet to remove the two rear flaps
of the roll neck from the seats on the shell sealing edge and remove it from the
helmet (Fig.20).
4 LINER DISASSEMBLY
4.1 Unhook the left rear flap of the liner from the shell rear edge by slightly puling the
comfort padding towards the inside of the helmet (Fig.21). Follow the same steps
for the right rear flap.
4.2 Hold the left front part of the liner and pull it upwards in order to remove the cor-
responding liner flap from the support fixed to the polystyrene inner shell (Fig.22).
Then repeat the same steps for the central front and right flap.
4.3 Completely remove the liner from the helmet.
5 LINER ASSEMBLY
5.1 Insert the liner correctly into the helmet and fit it well against the base.
5.2 Insert the central front flap of the liner into its seat on the support fixed to the pol-
ystyrene inner shell and push it downwards until it is completely locked (Fig.22).
Then repeat the operation with the left and right flaps making sure that the side
ends of the liner are placed between the external side frames and the polystyrene
inner shell.
Warning: Check the correct assembly of the liner front area by lifting and lowering
the VPS. These movements should be smooth. If this is not the case, repeat steps
4.2 and 5.2.
5.3 Insert the rear right and left flaps of the liner into the relevant lower seats on the
shell edge (Fig.21). Push the flaps until they are fully hooked onto the support.
6 ASSEMBLY OF THE ROLL NECK
6.1 Insert the rear right and left flaps of the roll neck into the relevant upper seats on
the shell edge (Fig.20). Push the flaps until they are fully hooked onto the support.
6.2 Insert the side flap into the seat on the lining of the left polystyrene cheek pad and
push it towards the inside of the helmet until it is completely locked to the support
(Fig.19).
6.3 Press the front button of the roll neck to fasten it to the corresponding seat on the
lining of the left polystyrene cheek pad (Fig.18).
6.4 Follow the same steps on the other side of the helmet.
24
INSTRUCTIONS FOR USE