Error Message; Technical Support - S&P RADIANT-1505 Manual De Instrucciones

5.9. ERROR message

If the error message (E1) appears on the screen, please contact the After Sale Services Ne-
twork if in Spain or your usual dealer in the rest of the world. To fi nd out where this is, you can
go to the WEBSITE: www.solerpalau.com
6. MAINTENANCE
Before starting any maintenance operation don't forget to let the device cool down for a few
minutes and unplug it from the mains.
• This product requires regular cleaning (at least once a year) to avoid dust build-up at the
rear (air inlet), as this could cause overheating.
• Unhook the device from the wall and clean the dust built up at the air inlet with a vacuum
cleaner.
• Clean the body of the device with a wet cloth. Do not use detergents or other abrasive pro-
duct that could damage the fi nish / colour of the plastic.
• Do not immerse the device or spray water onto it.
7. TAKING IT OUT OF SERVICE / RECYCLING END OF SERVICE LIFE/ RECYCLING
EEC law and the duty we have to future generations oblige us to recycle; please do
not forget to dispose of all the excess packaging in the corresponding recycling bins
and to take replaced devices to the nearest Waste management centre.
8. DISMANTLING, RECYCLING OR DISPOSAL OF THE PRODUCT AT THE END
OF ITS SERVICE LIFE
If scrapping the device, you must adhere to regulations on the disposal or recycling of the
materials and components.
List of the heater's main materials:
• PP plastic sides and base.
• Iron panel.
• Electronic tin plates.
• Electrical copper cables.
• Mica resistor.

9. TECHNICAL SUPPORT

The extensive Offi cial S&P Services Network provides any technical support you may require.
If you observe any anomaly in the device's operation, please contact any of the mentioned
18