Phonic MX 300 Manual Del Usuario página 6

3. Cue Split/Cue Mix Button
Cue Split function (button pressed): the cue signal
is on the one side of the headphones and the output
signal on the other side.
Cue Mix function (button released): the adjustable
mix of cue-signal and output-signal is on both sides
of the headphones.
4. Cue Level Control
With this knob, you can adjust the headphones
volume without changing the output signal.
5. Headphone Socket
Connect your headphone with impedance between
8 and 600 Ohms to this connector.
6. Cue Mixing Fader
Connect your headphones to the headphones socket
and select the desired channel for monitoring with
the Cue button. When you set the cue mixing fader
to PGM (cue button without function), you can cue
the output signal of the mixer. When this fader is set
at the center position, you can cue both the channel
signal you selected and the output signal.
7. Beat Indicator
The LED lights up at every bass beat of the respective
source. As soon as the LEDs flash synchronously, the
speed of the two sources is synchronized.
8. Master Level / Cue Level Display
The upper display shows the level of the left and right
master output, while the lower display shows the level
of the channel currently being cued (cue LED on).
9. Gain Control
Use this knob to set the level of input channel.
10. Treble Control
Used to increase or lower the HIs of the input
channel.
11. Middle Control
Used to increase or lower the MIDs of the input
channel.
6
12. Bass Control
Used to increase or lower the LOWs of the input
channel.
13. Phono /Line /Mic Switch
Use this switch to select the input to be sent to the
individual channel.
14. Crossfader Assign Selector
With this knob, you can choose whether channel 1
(button pressed) or channel 2 (button released) will
be assigned to the left crossfader-side. The other
channel remains active.
15. Channel Fader
Used to adjust the level of each channel.
16. Cue Button
Use this button in order to select the channel(s) to be
monitored. The red LED next to the button will come
up when its channel is being selected.
17. Crossfader
Mixes the signals of one channel with another. If the
crossfader is in the center position, both channels
can be heard.
18. 12V Lamp
BNC-socket for gooseneck lamp with a maximum
current 120 mA.
19. Power Switch
Press down the button to turn on this unit. The LED
will illuminate when the power is on.
20. Booth Control
You can connect your monitor system with this booth
socket on the back panel.
21. Balance Control
Used to adjust how much of the signal is sent to the
left and right master socket.
22. Master Control
Adjust the level of the master-output.
MX 300 / 306