Makita PW5001C Manual De Instrucciones página 7

1
2
► 1. Head cover 2. Side grip 3. Screw
Installing or removing the front grip
2
► 1. Head cover 2. Screw
CAUTION:
• Make sure that the front grip is installed securely
before operation.
• The front grip and the side grip cannot be
installed at the same time.
Remove two screws and then the head cover.
(The front grip cannot be installed during the installation
of head cover on the tool.)
Install the front grip on the tool so that its stopper fits to the gear
housing and tighten the two screws as shown in the figure.
(The front grip and the side grip cannot be installed at
the same time.)
1
2
► 1. Gear housing 2. Stopper 3. Front grip 4. Flat
washer 5. Hex socket head bolt
Installing or removing abrasive disc
(optional accessory)
3
► 1. Abrasive disc 2. Pad 3. Spindle
1
Remove all dirt or foreign matter from the pad. Screw the pad
onto the spindle with pressing the shaft lock. Attach the disc
to the pad so carefully that the edges of disc and pad overlap
each other without protruding.
To remove the abrasive disc, pull off its edge from the pad.
Hose connector assembly
3
4
► 1. Water cock 2. Hose connector 3. Connector
5
Use the hose connector assembly to connect to water
source. It consists of the following parts.
7 ENGLISH
1
2
3
4
4. Hose
Part name
Hose Connecter
Connecter
Hose
1
2
3
2
Description
1/2" pipe thread
1/2"mail pipe thread
5/8"in inner diameter x 25" in length