Makita PW5001C Manual De Instrucciones página 8

Assemble the above parts hand tight as follows.
1. Attach the hose connector to the outlet of water
cock.
2. Tighten the connector firmly to the hose. Insert the
connector to the hose connector as far as it will
go.
3. Tighten the hose connector to the end of the hose.
4. Fit the hose connector to the port on the tool.
OPERATION
Polishing operation
WARNING:
• To reduce the risk of electric shock, check the
tool's water supply system to ensure there is
no damage to the seals ("O" rings) or hoses.
A damaged water supply system may result in
abnormal water flow to the tool which could be
dangerous.
CAUTION:
• Always wear safety goggles or a face shield
during operation.
• Never switch on the tool when it is in contact
with the workpiece, it may cause an injury to
operator.
• Never run the tool without the abrasive disc. You
may seriously damage the pad.
• Be sure to feed water to the abrasive disc during
operation. Failure to do so may cause breakage
to the tool.
• The maximum permitted pressure of water
supply is 7 bar.
Make sure that the cock is closed. Connect the hose
to the tool. Make sure that water comes out when the
water lever is opened.
Hold the tool firmly. Turn the tool on and then apply the
abrasive disc to the workpiece.
Apply slight pressure only. Excessive pressure will
result in poor performance and premature wear to
abrasive disc.
MAINTENANCE
CAUTION:
• Always be sure that the tool is switched off and
unplugged before attempting to perform inspec-
tion or maintenance.
NOTICE:
• Never use gasoline, benzine, thinner, alcohol or
the like. Discoloration, deformation or cracks may
result.
► 1. Exhaust vent 2. Inhalation vent
The tool and its air vents have to be kept clean.
Regularly clean the tool's air vents or whenever the
vents start to become obstructed.
8 ENGLISH
1
2