Safety Notes
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Non-
•
Interlocked
Housing
•
Warning
Laser Safety
Notes
Laser Light is different from any other light sources with which you may be familiar. The
light from this product can potentially cause eye injury if not set up and used properly.
Laser light is thousands of times more concentrated than light from any other kind of light
source. This concentration of light can cause instant eye injuries, primarily by burning the
retina (the light sensitive portion at the back of the eye). Even if you cannot feel "heat"
from a laser beam, it can still potentially injure or blind you or your audience. Even very
small amounts of laser light are potentially hazardous even at long distances. Laser eye
injuries can happen quicker than you can blink.
It is incorrect to think that because these laser entertainment products split the laser into
hundreds of beams that the laser beam is scanned out in high speed, that an individual
laser beam is safe for eye exposure. This laser product uses dozens of milliwatts of laser
power (Class 3B levels internally) before it splits into multiple beams (Class 3R levels).
Many of the individual beams are potentially hazardous to the eyes.
It is also incorrect to assume that because the laser light is moving, it is safe. This is not
true. Nor, do the laser beams always move. Since eye injuries can occur instantly, it is
critical to prevent the possibility of any direct eye exposure. In the laser safety regulation,
it is not legal to aim Class 3R lasers in areas which people can get exposed. This is true
even if it is aimed below people's faces, such as on a dance floor.
Eclipse™ RGB User Manual
Please read the following notes carefully because they include important
safety information about the installation, usage, and maintenance of this
product.
Keep this User Manual for future consultation. If you sell this product to another user,
be sure that they also receive this document.
Always make sure that the voltage of the outlet to which you are connecting this
product is within the range stated on the decal or rear panel of the product.
This product is for indoor use only! To prevent risk of fire or shock, do not expose this
product to rain or moisture.
Make sure there are no flammable materials close to the unit while operating.
Always install this product in a location with adequate ventilation, at least 20 in (50
cm) from adjacent surfaces. Be sure that no ventilation slots are blocked.
Always disconnect this product from the power source before cleaning it or replacing
fuse.
Make sure to replace the fuse with another of the same type and rating.
If mounting it overhead, always secure this product to a fastening device using a
safety chain.
The maximum ambient temperature (Ta) is 104° F (40° C). Do not operate this
product at higher temperatures.
In the event of a serious operating problem, stop using the unit immediately. Never
try to repair the unit. Repairs carried out by unskilled people can lead to damage or
malfunction. Please contact the nearest authorized technical assistance center.
Never connect this product to a dimmer pack.
Make sure the power cord is not crimped or damaged.
Never disconnect the power cord by pulling or tugging on the cord.
Never carry a product from the power cord or any moving part. Always use the
hanging/mounting bracket or the handles.
Always avoid direct eye exposure to the light source when this product is on.
Lasers can be hazardous and have unique safety considerations. Permanent eye
injury and blindness is possible if lasers are used incorrectly. Pay close attention to
each safety statement in this User Manual. Read all instructions carefully BEFORE
operating this device.
This unit contains high power laser devices internally.
Do not open the laser housing, due to potential exposure to unsafe levels of laser
radiation.
The laser power levels, accessible if the unit is opened, can cause instant blindness,
skin burns, and fires.
STOP AND READ ALL THE LASER SAFETY NOTES BELOW
5
Rev. 8 ML