Installation - wikango WK800 Manual Usuario

VI Installation instructions:
1) Turn off the device.
2) Insert the microSD card into the card slot.
Caution Make sure that a high speed microSD card (Class 10 or higher),
capacity not less than 8G, is used. Before using it for the first time,
format the memory card from the camera in the menu.
3) Install the camera in the magnetic holder, and then stick the bracket
on the windshield, taking into account the angle of inclination.
4) Connect the extension cable to the microUSB port of the magnetic
holder and the car charger to the cigarette lighter socket of the vehicle.
Remarks The extension cable can be wired along the edge of the
windshield. So that the installation of the wiring is hidden.
5) Adjust the position of the camera, to make sure that the lens is
parallel to the ground. The support has several adjustment angles so
you just have to stretch the support from bottom to top
6) Start the engine, to verify if the camera turns on and is installed
correctly.
Remarks If the WK800 is not properly connected, the side LED light will
not be on. If the camera starts recording, you will see a small red circle
blinking in the upper left.
ENGLISH I 24