EHEIM powerLED+ fresh daylight Manual De Instrucciones página 13

English
The distance from the underside of
the light to the highest water mark
must be a minimum of 15 mm.
4. Commissioning
1. The LED lights can be adjusted to the width
of your aquarium with the freely adjustable
extendable bracket
bracket out of the light housing until it
reaches the desired length.
Electrical connection
1. Connect the plug of the LED lights to the
socket of the matching EHEIM power supply
unit.
The matching EHEIM power supply unit can be
found on the packaging of your LED light.
5. Operation
Service life
In order to avoid excessive algae formation,
you should not put the LED lights in continuous
operation.
Optional accessories
Use with Y distributor
The Y distributor allows you to operate two LED lights from
one power supply unit.
Ensure that the maximum power output of the
power supply unit is not exceeded (see Techni-
cal Data, page 107)
Use with T5/T8 adapter
cent bulbs with an LED light. To do so, proceed as follows:
1. Push both adapter parts
extendable bracket (
Attention! Electrocution!
Before all assembly work, remove the mains
plug of the lighting unit and or cover.
Keep the lighting unit or cover disconnected
from the mains!
Secure the mains plug of the lighting unit or
cover against any unintentional connection
to the socket
2. Loosen the end cap
bulb.
13
. Pull the extendable
-
/ until they click onto the
).