Publicidad
Idiomas disponibles
Idiomas disponibles
Keyring type remote control
for automatic door
User Manual
PLACEMENT AND REPLACE THE BATTERY
1. Use a screwdriver to open the control.
2. Install a CR2032 battery. Ensure that the
polarity is correct.
1.
Use a clip or a pointed object to press the
learn button in the remote control. The indicator
light will on.
2.
Choose some of the three buttons of the
control and press it the times that corresponding
with the type of motor frequency as shown below.
Then, exit from programmiing mode.
# times that you must pressing
Frequency of the motor
the button in the control
1
Security+ 2.0
315 MHz Security+ ®
2
3
390 MHz Security+ ®
390 MHz Billion code
4
If you does not know the frequency, press and release the button until
you notice that the LEARN indicator (in the motor) flashes.
IMPORTANT CONSIDERATIONS
○To exit from the programming mode press any button in the remote control.
If you press the same button again, the frequency will change and the pairing with
the motor will lose.
○Do not exceed the 30 seconds between each step, otherwise you will must repeat
all process
○During the programming don't must make any movement in the motor.
V0.0/0917v
CONTROL PROGRAMMING
3.
In the motor of the door press the LEARN button and follow the corresponding
programming mode
A - To "LEARN" button yellow / green /
purple...
1. Press once the button. The indicator
LED must remains on.
2. Press and hold the programmed
button in the remote control until you can
hear two clicks in the motor or the lights
flashes.
Before to use the product, please read carefully this manual to avoid any malfunction.
The info in this manual is shown as reference. Due to updates can exist differences. Consult
our website www.steren.com to obtain the current version of this manual.
• This product is NOT a toy; keep it away from children.
• Don't obstacle the door's trajectory.
• Always pay attention when you do use the control.
• Any reparation not authorized may cause malfunction and avoid the warranty.
BEFORE TO USING...
Identify the LEARN buttons in the motor of the door and in the remote control.
NOTE
The location, the color and the shape of the LEARN button may vary according with the
model of the motor.
For models of motor later to 2010 the buttons are red/orange is necessary the wall buttons
for programming, since in this cases the "LEARN" button only works to delete.
B - To "LEARN" button red / orange...
1. Identify the wall button: Button A (light
control) Button B (start the motor).
2. Press the programmed button in the
remote control and the A and B buttons
at the same time. Press and hold the
three buttons simultaneously until hear
two clicks in the motor or the lights
flashes.
SPECIFICATIONS
Input: 3 V - - - (1 x CR2032)
Operating frequency: 315 MHz and 390 MHz
Specifications may change without notice
CAUTIONS
4.
Wait for a few seconds until the LEARN
indicator is off, then press the programmed
button. The motor will activate normally.
Publicidad
