HQ TVS--TFSB01B Manual De Uso página 2

ASSEMBLY INSTRUCTIONS FOR FIXED FLAT PANEL WALL MOUNT
This product is designed to mount flat panel televisions weighing up to 45 kg → TVS-HQ-TFSB01B,
55 kg → TVS-HQ-TFSB02B, 65 kg → TVS-HQTFSB03B to a vertical firm wall.
Safety Warning: Be careful to make sure there are no missing or defective parts. Never use defective
parts. Improper installation may cause damage or serious injury.
Note: The included hardware is for mounting on a wall. If you are uncertain about the nature of your
wall, consult an expert. Please consult your hardware or installation professional for proper mounting
to other types of walls. The supplied hardware is not for steel.
Forbidden: Do not mount onto plasterboard or a paneled wall.
Hardware kit
a
M4x30mm Screw
d
M5x12mm Screw
g
M6x30mm Screw
j
Concrete Anchor
m
Small Spacer
Attaching the Arms to the Display
Important! Use extra care during this part of the installation. If possible, avoid placing the display face
down as it may damage the viewing surface.
Note: Your mount comes with a selection of bolt diameters and lengths to accommodate a wide variety
of display models. Not all of the hardware in the kit will be used.
1. Determine the correct length of bolts to use with your display by first examining the back of your
display.
A. If your display has a flat back, you will use one of the shorter bolts from the hardware kit.
B. If your display has a curved or recessed back, you have to use one of the longer bolts along
with a spacer.
2. Determine the correct diameter of the bolts to be used by carefully trying each bolt from the
hardware kit. Do not force any of the bolts - if you feel resistance stop immediately and use a
smaller diameter bolt.
3. Attach the arms to the back of your display using the bolts identified along with the corresponding
washers.
A. If you are using the M4 or M5 bolts, you will also need to use the small hole of the washer n.
If you are using the M6 or M8 boles, you will also need to use the big hole of the washer n.
B. If you are using one of the longer bolts on a display with a curved recessed back, you will
also need a spacer. Use the small spacer for M4 and M5 bolts and the large spacer for M6
and M8 bolts.
ENGLISH
x4
b
M4x12mm Screw
x4
e
M5x30mm Screw
x4
h
M8x25mm Screw
x6
k
6mm Lag Bolt
x4
n
Washer
x4
c
x4
f
x4
i
x6
l
x4
o
2
x4
M5x10mm Screw
x4
M6x12mm Screw
x4
M8x40mm Screw
x4
Big Spacer
x6
Lag Bolt Washer