HQ TVS--TFSB01B Manual De Uso página 3

4. Make sure all screws are secure, but do not over-tighten them.
1
Diagram1
Mounting the Wooden Wall Plate
Important! For safety reasons the mount must be secured to two
adjacent wood studs at least 40.5cm apart.
Using a stud finder, locate and mark two adjacent studs for securing
the mount. Place the wall plate against the wall and level it using a
water leveler. Mark two positions (two per stud) on the wall where the
mount will be secured. Remove the wall plate and drill a (4mm) pilot
hole in each position with an electric drill.
1. With the help of another person, replace the wall plate and fix it to
the wall using the lag bolts and lag bolt washers provided.
2. Do not over-tighten the bolts and do not release the wall plate until
all screws are secure.
Mounting the Concrete Wall Plate
1. Place the wall plate against the wall and level it using a water
leveler.
2. With the help of another person mark four (4) positions for fixing
the mount to the wall.
3. Place the wall plate aside and drill a hole at each position using
a 10mm masonry bit. Remove any excess dust form the holes.
4. Insert one concrete anchor into each hole. A hammer can be
used to lightly tap the anchors into place if necessary.
5. With the help of another person replace the wall plate and fix it
to the wall using the lag bolts and lag bolt washers provided.
6. Do not over-tighten the bolts and do not release the wall plate until all screws are secure.
Final Installation and Adjustment
With the help of another person carefully lift your display and place it on the wall plate. Do not release
the display until the mounting arms have securely hooked onto the mount.
Maintenance:
Clean only with a dry cloth. Do not use cleaning solvents or abrasives.
Warranty:
No guarantee or liability can be accepted for any changes and modifications of the product or damage
caused due to incorrect use of this product.
General:
Designs and specifications are subject to change without notice.
All logos brands and product names are trademarks or registered trademarks of their respective
holders and are hereby recognized as such.
Keep this manual and packaging for future reference.
2
Diagram2
3
3
Diagram3
Diagram5
Diagram4