Metalworks CAT 210 Manual De Instrucciones página 10

1 Safety
Notice: Any blast cabinet will produce a powerful flow of abrasive particles. To avoid personal injury and property
damage, study this manual thoroughly before assembling, operating or servicing this blast cabinet.
Failure to follow these instructions could result in operator injury as well as damage the blasting system.
• Your blast cabinet is designed for cleaning, polishing and finishing with dry abrasive ONLY, such as glass bead or
plastic granule abrasives. The finishes can vary from coarse to fine according to the sizing of the glass bead. On
delicate parts, start out with minimal air pressure to avoid unnecessary peeling or undesired, excessive abrasion.
• Do notice your blasting system is equipped with a 3-prong grounded plug for protection against shock. When
connecting your unit obey all applicable electrical and safety codes. The blasting system should be plugged
into an adequately grounded 3-prong receptacle. If only a 2-pong receptacle is available, have it replaced with
the applicable national and local codes or ordinances. Only a qualified electrician should perform this work. A
grounded adaptor can be used. Make sure the green lead of the adaptor is properly attached to a suitable electric
ground.
• Abrasive media is very slippery and should be cleaned up immediately to avoid possible operator injury.
2 Assembling the blast cabinet
1. Connect front panel (2), rear panel (3),
right panel (4R), left panel (4L) and screw up
all of the screws.
3. Secure the glove (21) with glove clamp
(22) onto the front panel as illustrated.
10
®
2. Connect the base of the four legs (7A and
7B), then put screen (23) in the cabinet.
4. Connect the lamp clamp (6) as illustrated.
CAT210 - NLFRENES - v2.0 - 16072013
EN