EHEIM 3500 Manual De Instrucciones página 11

Ocultar thumbs Ver también para 3500:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 26
English
‧ We recommend protecting all electrical aquarium appliances
via a residual current protective device with a rated residual
current of 30 mA maximum.
‧ If they are not being used, always disconnect all devices in
the aquarium from the power supply before you install/remove
any parts and before all cleaning and maintenance work.
‧ Protect the mains socket and mains plug against
moisture and wetness. A drip loop must be
formed with the mains cable. This prevents any
water running along the cable to the mains
socket, which would result in a short-circuit.
‧ The electrical data of the appliance must match the data of
the power mains. This data is found on the type plate, the
packaging and in these instructions.
4.
Commissioning
Assembly
Danger! Electrocution!
▶ Ensure that there is a sufficient distance between the two-outlet power strip and the water.
1. Place the control unit and the two-outlet power strip on a level, dry surface.
2. Only place the control unit in a horizontal position.
5.
Operation
Connecting the pumps
Caution! Material damage.
▶ Each socket of the two-outlet power strip may have an output of no more than 100 W.
1. Plug the mains plugs of the pumps into the sockets of the two-outlet power strip.
The control unit works with multiple pumps at each socket of the two-outlet power strip. Please
ensure that the sum of the power consumption does not exceed the maximum value of 100
Watt per socket.
Switching the control unit on/off (⌦A)
1. Turn the control unit on (I) at the on/off switch
away!
2. Turn the control unit off (0) with the on/off switch.
Program A is activated when it is switched on.
. Attention: The pumps will start right
a
11

Publicidad

Tabla de contenido
loading

Tabla de contenido