Toa WM-D5300 Serie Manual De Instrucciones página 13

8.2.2. Performing encryption settings
[switching the encryption function from OFF to On]
See also the instruction manual enclosed with the WT-D5800 receiver.
step 1. Enable the receiver's encryption function.
step 2. With the battery cover removed, switch ON the transmitter power
switch and confirm that the Encryption indicator is unlit.
If the indicator is lit, switch encryption from ON to OFF (see p. 14).
step 3. Switch OFF the transmitter power switch.
step 4. Switch ON the transmitter power switch while holding down the
transmitter's Encryption setting switch (continue holding until step 6).
Confirm that the transmitter's Encryption indicator is flashing.
An ID number is transmitted while the transmitter's Encryption
setting switch is held down.
step 5. Perform pairing setting at the receiver.
The receiver waits for the transmitter's transmitted ID number for
as long as the Set key is held down. The "RECEIVING" indication
is displayed on the receiver's LCD screen until the ID number is
correctly received.
step 6. After confirming that the LCD display has switched to the "SUCCESS"
indication, release both the transmitter's Encryption setting switch
and the receiver's Set key.
step 7. Confirm that the transmitter's Encryption indicator is lit.
The encryption setting is now ON.
notes
• Do not switch OFF the power to the transmitter or receiver during setting.
• Hold down the transmitter's Encryption setting switch and the receiver's
Set key until the "SUCCESS" indication appears on the receiver's LCD
screen. If the transmitter's Encryption setting switch or the receiver's Set
key is released while the "RECEIVING" indication is displayed on the
receiver's screen, the receiver will not have correctly received the new ID
number, leaving the ID number unchanged from the previous value. To
match the receiver ID number with the transmitter ID number, switch OFF
the transmitter's encryption setting, then repeat steps 1 – 7 above.
tips
• The ID number is updated when the encryption is switched from OFF to ON again. (The encryption
ON/OFF status and ID number are retained even if the power switch is switched OFF.)
• Settings can be performed regardless of whether the transmitter or receiver Encryption setting
switch was depressed first.
• The receiver does not output audio during ID number setting, even if it receives a radio signal from
the transmitter.
Unlit
Flashing
Lit
13