Publicidad
Idiomas disponibles
Idiomas disponibles
PROBLEM
Laser line
projection
is weak_
Laser line
is hard to
seer
Laser line
is not
projected,
Laser line
projected
is not level.
CAUSE
Batteries
are weak_
Light in area
is too bright
Power switch
is not "on".
SOLUTION
Replace with fresh batteries
Use laser enhancing glasses.
Check to be sure the power
switch cover is in the full
down or "on" position.
1. Thumb knob is
not in correct
position_
2, Level is mounted
on the thin-pin wall
mounting base,
3. Level is mounted
on the precision
leveling base, but
the base is no
longer level
1, Adjust thumb knob°
2. Align the tool using two
points of reference in the
work area or place the tool
on the precision leveling
base.
3. Check the leveling vials on
the top of the tool, and
adjust the three base plate
knobs to bring the tool back
into a level position,,
'14
Publicidad
