Before Using Your Converter - Schumacher Electric SI1000 Manual Del Usuario

3. CONVERTER LOCATION
3.1 Never place unit directly above battery;
gases from battery will corrode and
damage the converter.
4. FEATURES
• ON/OFF rocker switch
• LED indicator
Green indicates Power ON
Red indicates Overload/Interruption
in power
• 12 Volt power cord
• 120V standard AC outlets (2)
• USB port– 5V, 2.0A
• High-speed cooling fan
To keep the converter cool, the fan speeds
up as the load increases. The fan does
not run when the converter is turned off.
• Positive Battery Cable Terminal (Red)
• Negative Battery Cable Terminal
(Black)

5. BEFORE USING YOUR CONVERTER

Do not use the converter with a product
that draws a higher wattage than the
converter can provide, as this may cause
damage to the converter and product.
When you turn on a device or a tool that
runs on a motor, the device goes through
two stages:
1. Start Up – Requiring an initial surge
of power (commonly known as the
"starting" or "peak" load).
2. Continuous Operation – Power
consumption drops (commonly known
as the "continuous load").
The wattage (WATTS) or amperes (AMPS)
can normally be found stamped or printed
on most devices and equipment, or in
the user's manual. Otherwise, contact
the manufacturer to find out whether the
device you want to use is compatible with
a modified sine wave.
To calculate the wattage:
Wattage = AMPS x 120 (AC Voltage).
To calculate the starting load:
Starting Load = 2 x wattage.
3.2 Never allow battery acid to drip on unit
when reading gravity or filling battery.
3.3 Do not operate converter in a closed-in
area or restrict ventilation in any way.
• Ground Terminal and ground wire
Grounds converter, to protect against
electrical shock.
• Thermal Protection
When the thermal resistor exceeds
80° C (176° F), the converter shuts
down until it cools off, and then
automatically restarts.
• Surge Protection
When the power input from the
vehicle's battery exceeds 16 volts, the
converter shuts down. Once the voltage
drops down to less than 14 volts, it
automatically restarts.
• Low-Battery Protection
When the power input from the vehicle's
battery drops to below 10.5 volts, the
alarm will sound, the red LED will light,
and the converter will shut down.
In general, the startup load of the device
or power tool determines whether your
converter has the capability to power it.
To calculate the continuous load:
Continuous Load = AMPS x 120
(AC Voltage).
IMPORTANT: Always run a test to
establish whether the converter will
operate a particular piece of equipment or
device. In the event of a power overload,
the converter is designed to automatically
shut down.
This safety feature prevents damaging
the converter while testing devices and
equipment within the wattage range of the
converter.
If a device does not operate properly
when first connected to the converter, turn
the converter ON/OFF switch ON, OFF,
and ON again in quick succession. If this
procedure is not successful, it is likely that
the converter does not have the required
capacity to operate the device in question.
• 3 •