Auto Off Function - LaserLiner MultiMeter-Pocket Manual De Instrucciones

5
HOLD
4
3
MODE
2
1 Rotary switch to set the
measuring function
2 ON/OFF ashlight
3 Switch over measuring
function
4 LCD
5 Sensor (non-contact voltage
detector)
6 Indicator (non-contact voltage
detector)
7 Holder for test prods
8 Hold actual measured value
9 Measuring contacts:
red „+", black „–"
10 Test prods

AUTO OFF function

In order to preserve the batteries, the meter switches off
automatically if it is left idle for 15 minutes.
12
GB
6
9
7
8
HOLD
1
red
D
C
B
10
black
A Measured value display
(3.5 segments, 1999 digits)
B Negative measured values
C Direct (DC) or alternating (AC)
variables
D Automatic range selection
E Diode test
F Continuity test
G Actual measurement is
retained
H Low battery charge
I Measurement units:
mV, V, A, mA, Ohm,
kOhm, MOhm
Display: O.L: Open line/
over ow: measuring circuit
not closed or measuring
range exceeded
E F G H
HOLD
A I