Removing The Collected Water - Carrier CDG-105E Manual Del Propietário

OPERATING THE UNIT

Removing the collected water

There are two ways to remove collected water.
1. Use the bucket
● When the unit is off,if the bucket is full, the unit will beep
8 times and the Full indicator light will flash, the digital
display shows P2.
● When the unit is on,if the bucket is full, the compressor
turns off and the fan turns off after 30 seconds for drying
the water of the condenser, then the unit will beep 8
times and the Full indicator light will flash, the digital
display shows P2.
● Slowly pull out the bucket. Grip the left and right handles
securely, and carefully pull out straight so water does not
spill. Do not put the tank on the floor because the bottom
of the bucket is uneven. Otherwise the bucket will fall
and cause the water to spill.
● Throw away the water and replace the bucket. The
bucket must be in place and securely seated for the
dehumidifier to operate.
● The machine will re-start when the bucket is restored in
its correct position.
NOTES:
● When you remove the bucket, do not touch any parts
inside of the unit. Doing so may damage the product.
● Be sure to push the bucket gently all the way into the
unit. Banging the bucket against anything or failing to
push it in securely may cause the unit not to operate.
● When you remove the bucket,if there is some water in
the unit you must dry it.
2. Continuous draining
Water can be automatically emptied into a floor drain by
attaching the unit with a water hose (not included).
● Remove the rubber plug from the back drain hose outlet.
Attach a drain hose (ID=13.5mm) and lead it to the floor
drain or a suitable drainage facility (see Fig.7).
● Make sure the hose is secure so there are no leaks.
● Direct the hose toward the drain, making sure that there
are no kinks that will stop the warter flowing.
● Place the end of the hose into the drain and make sure
the end of the hose is level or down to let the water flow
smoothly. Do never let it up.
● Select the desired humidity setting and fan speed on the
unit for continuous draining to start.
NOTE: When the continuous drain feature is not being
used,remove the drain hose from the outlet.
09
1. Pull out the bucket a little.
2. Hold both sides of the bucket
with even strength, and pull it
out from the unit.
3. Pour the water out.
Remove the
rubber plug
Attach the hose
to the drain hose
outlet.
Fig.5
Fig.6
Fig.7