LaserLiner AC-tiveMaster Digital Manual De Instrucciones página 11

2 Functional test/Self-test
sources
test (13) lights up and a signal sounds.
the test, the LEDs for the continuity test (13) as well as all
segments of the bar graph light up and a signal sounds.
3 Voltage test
To achieve the protection class CAT III 1000 V and
!
over the test prods.
and as a bar graph.
4 Single-pole phase test
L2, L1 remains free during the measurement. The LED (9) will
light up if an AC voltage is applied on the conductor.
charged batteries inserted.
voltage of approx. 100 V AC.
conductor, the indicator function may be adversely affected
under certain conditions (e.g. when insulating personnel
protective equipment is used or at insulated locations).
The single-pole phase test is not suitable for checking
!
for zero voltage. To do this, you need to carry out a
two-pole phase test.
AC-tiveMaster Digital
Hold the base device (+)
in your right hand and the
second test prod (-) in your
left hand. Now apply the test
prods to the contacts to be
tested (line, socket, etc.).
11
GB