Tintometer TC-Serie Manual De Operation página 15

11
12. Turn the door by 180°.
12
13
13. Insert the pin into the left-hand door mount-
ing.
Use your index finger to hold the pin while
you are assembling the door.
14. Locate the door on the upper
pin as shown in the illustration
and guide it to the lower hinge
bracket.
Important
As a result of its heavy weight,
the door must be held secure by
one person.
15. Lift the door upwards and turn
the pin until it fits into the bore
hole of the hinge bracket.
Slowly lower the door downwards.
The lower part of the pin must
be fully engaged in the bore hole
of the hinge bracket.
TC 135 S / TC 255 S / TC 445 S_4 09/2018
11. Screw hinge brack-
et into place.
14
15
16. Screw the screw into
the pin again and
tighten.
Adjusting the lateral tilt of the door
If the door is at an angle, adjust the angle.
17. Remove middle screw from hinge
bracket.
This screw is no longer needed.
18. Undo screws and slide
hinge bracket to the right
or left.
Tighten screws.
16
17
18
GB
15