Maintenance; Decommissioning; Warranty; Troubleshooting - Schneider Airsystems SBS-SET Manual De Instrucciones

GB
SLM
2. Press the quick-action coupling of the air
hose onto the plug nipple (item 01)
(Figure 1a).
Operation:
1. Attach the tool to the object being pro-
cessed.
2. Actuate the safety lever (item 08), if
available (Fig. 6a) and press the trigger
lever (item 02).
3. If there is no trigger lever (item 02):
Turn the rotary valve / air regulation
(item 03) accordingly (Fig. 7a).
4. If air regulation available:
adjust the
regulation point (item 03) (Fig. 8a).
After use:
1. Disconnect the quick-action coupling
from the plug
(Figure 1b).
2. Remove the abrasive / tool.

2.5 Maintenance

Regular lubrication is required!
Oil using a maintenance unit
with filter pressure reducer and mist oiler.
Without mist oiler: oil daily by hand via the
plug nipple (item 01).

2.8 Troubleshooting

Problem
A Minimum or no
operating capacity
*For troubleshooting: refer to the information in the "Technical data" chapter in part 1 of the instruction manual!
**See Chapter: "Intended use" in Instruction manual part 1!
***For troubleshooting: read chapter: "Commissioning"!
****For troubleshooting: read chapter: "Maintenance"!
If necessary, contact our service staff, see last page.
II/6
torque at the
nipple (item 01)
Cause
Air regulation (item 03) set-
ting incorrect
Abrasive / Tool worn
Working pressure (flow pres-
sure) too low
Compressor output too small
Hose diameter too small
In the event of longer interruptions in op-
eration, also
nipple (item 01).

2.6 Decommissioning

Storage: Clean, dry, dust-free, not below
5° C.
Disposal: Dispose of the packaging / device
/ materials used according to applicable legal
regulations.

2.7 Warranty

Basic principle: complete unit in original
condition / proof of purchase.
Material and production defects are covered
air
by statutory provisions.
Excluded warranty claims: Wear or ex-
pendable parts, improper use, overloading /
incorrect pressure, manipulation / inappro-
priate use, inadequate / incorrect / lack of
maintenance or lubrication, bumps / im-
pacts, dust / dirt accumulation, unauthorised
/ incorrect working procedures, incorrect
power supply, impure / insufficiently filtered
compressed air, failure to read the instruc-
tion manual, incorrect operating resources /
materials.
Remedy
Adjust the air regulation setting
correctly
Replace abrasive / tool
Increase working pressure (flow
pressure)
working pressure
Use suitable output capacity
Use correct hose diameter
lubricate via the
***
*
Observe maximum
*
plug
*
*