Hema 80.07.0022 Instrucciones De Uso página 22

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

Before storing, allow it to cool down.
Do not crease the appliance by placing items on top of
it during storage.
The appliance is not intended for medical use in hospital.
The appliance is not to be used by young children over the
age of three unless the controls have been pre-set by a
parent or guardian, or unless the child has been
adequately instructed on how to operate the controls
safely.
If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
The plastic bag around the blanket is used for hygienic
reasons.
The appliance is only to be used with the detachable
control unit PS7G-H/L that are marked on the appliance.
When not in use, please follow the instructions of below
paragraph of the manual.
Regarding the instructions for appropriate settings of
controls for continuous use of the appliance, please refer
to the below paragraph of the manual.
Use of the blanket:
This blanket is intended to be used as an "over-blanket" and therefore should always
be placed on top of an individual, not under them or on the top of a bed sheet. It is
not to be used as an "under-blanket".
• Make sure the cord set from the blanket is firmly attached to the blanket itself.
• Insert the plug of the electric blanket (F) into the connector of the electric blanket
(G).
• Insert the plug into the socket (220-240 V AC/50 Hz).
• Slide the power switch to position "ON". The appliance is in standby state. The
digital display shows "0" for the temperature setting and "0" for the timer setting.
• Press the button "Temp" to select your desired temperature setting: L (lowest) – 1 – 2
– 3 – 4 – 5 – 6 – 7 (from low to high). The timer is set at 9 (hours) by default.
• Press the button "Time" to select your desired timer setting: 1 – 2 – 3 – 4 – 5 – 6 – 7 –8
– 9 (hours).
• If needed press the button "High" to set the temperature at the highest level. The
digital display will show "H" and will automatically change to "L" in 1 hour.
• After use, press the power switch to position "OFF" and unplug the appliance from
the mains socket.
Take note: The mains socket must be nearby and accessible.
22

Publicidad

Tabla de contenido
loading

Tabla de contenido